About seller
Pashmina, the world's finest natural fiber is derived from secondary hair follicles of Changthangi goats which are domesticated in Ladakh region of Jammu and Kashmir by nomadic pastoralists. Complex epithelial-mesenchymal interactions involving numerous signal molecules and signaling pathways govern hair follicle morphogenesis and mitosis across different species. The present study involved transcriptome profiling of skin from fiber type Changthangi goats and meat type Barbari goats to unravel gene networks and metabolic pathways that might contribute to Pashmina development. In Changthangi goats, 525 genes were expressed at significantly higher levels and 54 at significantly lower levels with fold change >2 (padj less then 0.05). Functional annotation and enrichment analysis identified significantly enriched pathways to be formation of the cornified envelope, keratinization and developmental biology. Expression of genes for keratins (KRTs) and keratin-associated proteins (KRTAPs) was observed to be much higher in Changthangi goats. A host of transcriptional regulator genes for hair follicle keratin synthesis such as GPRC5D, PADI3, HOXC13, FOXN1, LEF1 and ELF5 showed higher transcript abundance in Pashmina producing goats. Positive regulation of Wnt signaling pathway and negative regulation of Oncostatin M signaling pathway may be speculated to be important contributors to hair follicle development and hair shaft differentiation in Changthangi goats.An amendment to this paper has been published and can be accessed via a link at the top of the paper.In this study, a redox precipitation method was used to load manganese dioxide (MnO2) nanoparticles on biochar (BC) (BC@MnO2) pyrolyzed from the invasive water hyacinth, and the adsorption of Cd(II),Cu(II), Zn(II), and Pb(II) was investigated. Several techniques were used to characterize the adsorbents. The results revealed that the BC surface was covered by many intertwined thin amorphous MnO2 nanosheets, which significantly increased its specific surface area and pore volume. The adsorption of heavy metal ions by BC was negligible, whereas the MnO2-containing adsorbents exhibited a high capacity for adsorbing heavy metal ions. However, the MnO2-normalized adsorption amount decreased with increasing MnO2 load and was largely unchanged at MnO2 loads of 26.6% to 30.2%. The capacity for adsorbing heavy metal ions of BC@MnO2 was pH-dependent, but the adsorption affinity was unaffected by coexisting ions. Column tests revealed that BC@MnO2 with a load of 26.6% had a high capacity for removing heavy metal ions from simulated and real electroplating wastewater. Therefore, BC@MnO2 with a load of 26.6% shows promise as a regenerable adsorbent for removing heavy metal ions from water/wastewater. This study could lay an essential foundation to develop a win-win strategy for heavy metal ions removal from wastewater using biochar derived from water hyacinth.Chronic obstructive pulmonary disease (COPD) is a chronic inflammatory airway disease requiring frequent outpatient visits and lifelong management. We aimed to evaluate the roles of frequent outpatient visits in prognosis of COPD. We used claims data in the national medical insurance review system provided by the Health Insurance Review and Assessment Service of Korea from May 1, 2014 to April 30, 2015. A definition of COPD was used based on the diagnosis code and medication. Frequent visitors were defined as subjects who visited the outpatient clinic for COPD three or more times per year. Among 159,025 subjects, 117,483 (73.9%) were classified as frequent visitors. Frequent visitors underwent pulmonary function tests and used various inhalers more often than did infrequent visitors. The rates of COPD exacerbation requiring admission to a general ward, emergency room, or intensive care unit were significantly lower in frequent visitors than in infrequent visitors. In multivariable analysis, frequent visits were identified as an independent factor preventing COPD exacerbation that required admission to a ward (odds ratio [OR], 0.387), emergency room, (OR, 0.558), or intensive care unit (OR, 0.39) (all P less then 0.001). In conclusion, we showed frequent outpatient visits reduce the risk of COPD exacerbation by 45-60%.Cardiopulmonary resuscitation (CPR) resuscitates patients suffering from cardiac arrest. Mechanical chest compression CPR highlights the need for high CPR quality to facilitate survival and neurological recovery. However, current CPR devices cannot be used on pregnant women or infants. These devices' long re-setup times interrupt CPR and can cause cerebral ischemia. This study designed a novel device with a crank-sliding mechanism. The polar coordinate system (r, θ, z) shortened the setup time and enabled adjustment without moving the patient. We compared our device with commercial products (e.g., LUCAS-2) by quantifying the compression pressure. Control groups for manual CPR of trained physicians and untrained citizens were recruited. We used Resusci Anne products as models. Tatbeclin1 Our results indicated that our design exhibited performance similar to that of LUCAS-2 in adults (557.8 vs. 623.6 mmHg, p = 0.217) and met the current CPR standard guidelines. Notably, our device is applicable to pregnant women [565 vs. 564.5 (adults) mmHg, p = 0.987] and infants [570.8 vs. 564.5 (adults) mmHg, p = 0.801] without lowering the compression quality. The overall compression quality and stability of mechanical chest compression CPR were favorable to those of manual CPR. Our device provides an innovative prototype for the next generation of CPR facilities.Possibilities of enhancing mechanical properties of brittle intermetallic containing high entropy alloys (HEAs) using novel processing and microstructural design strategies were investigated in the present work. For this purpose, homogenized CoCrFeNi2.1Nb0.2 HEA consisting of FCC matrix and complex Laves phase particles was successfully processed by severe cold- or cryo-rolling to 90% reduction in thickness followed by annealing (800 °C/1 hour(h)). As compared to cold-rolling, cryo-rolling resulted in a finer lamellar nanostructure and decidedly greater fragmentation of the Laves phase. Upon annealing, the cold-rolled HEA showed a recrystallized FCC matrix dispersed with D019 structured ε nano-precipitates. In contrast, the finer nanostructure and greater driving force for accelerated precipitation of profuse nano-precipitates at the early stages of annealing inhibited recrystallization in the cryo-rolled HEA and resulted in the formation of heterogeneous microstructure consisting of retained deformed and recrystallized regions.