This allows selection and manipulation (e.g., co-addition, subtraction) of the pixel output spectra to minimize optical interference fringes thereby increasing sensitivity. We demonstrate a factor of ∼20 sensitivity improvement over traditional single-element detection. Dynamic range increase of a factor of ∼100 is also demonstrated through spot selection representing different pathlengths. Additionally, subtracting the spectrum of the first spot from that of the higher pass normalizes the laser power and removes the contribution of contaminant gas and fringes in the fore-optics region. These initial results show that this imaging method is particularly advantageous for multi-channel laser spectrometers, and, once the image field is analyzed, pixel selection can be used to minimize data rate and volume collection requirements. This technique could be beneficial to enhanced-cavity detection schemes.We developed a high-power amplified spontaneous emission (ASE)-free fast wavelength-switchable external cavity diode laser (ECDL) using a digital micromirror device (DMD) as the wavelength selector. Generally, with a conventional fast wavelength-switchable ECDL with a DMD, the output power is limited by the damage threshold of the DMD. However, with our ECDL, a high-power output was realized by optimizing the beam focus on the DMD. In addition, an ASE-free stable output was realized through the introduction of a ring cavity. As a result, we successfully developed a fast wavelength-switchable ECDL realizing a high-power ASE-free output of over 300 mW.We investigate theoretically and numerically one-dimensional three-periodic photonic crystals of the structure [(SiO2/TiO2)N(Al2O3/ZrO2)M]K, formed by dielectric oxides SiO2, TiO2, Al2O3, and ZrO2 (N and M are the number of subperiods, and K is the number of superperiods). We study the transmission spectra, energy and power fluxes of TE- and TM-polarized electromagnetic waves for a photonic crystal, characterized by the sharp PBG edges, and narrow and pronounced peaks of defect modes. The angular distance (difference in the incidence angles) between the transmission peaks of different polarizations is shown to be about 1.5°, which is 5 times more than in the ternary photonic crystals. The results can be useful for designing highly efficient optical devices operating in the infrared regime on the side-surface of the photonic crystal, such as polarization-sensitive couplers and angle sensors for optical fiber systems.This paper presents an optimization-based method for phase extraction from interferograms corrupted with noise, rapid phase variations, and localized amplitude fluctuations. In the proposed method, the phase retrieval problem is addresed by modeling a cost function using non-convex non-smooth total generalized variational regularization. Further, the surrogate principle is used to transform the cost function into convex form for convenient optimization framework. Simulation results demonstrate the performance of the method. We also show the experimental utility of the proposed method for onion cell imaging using digital holographic microscopy.The optoelectronic oscillator (OEO) generates low-phase noise and high-frequency microwave signals thanks to a high Q-factor cavity with long and low-loss fiber delay. Traditionally, for the desired mode selection from the ultradense cavity modes, a narrowband electrical filter is needed, whose frequency tuning is very limited. On the other hand, for a tunable OEO offered by a microwave photonic filter (MPF), a paradox existed between the large number of cavity modes and the wide MPF bandwidth. Here, we achieve a tunable OEO using the mode-selection mechanism of parity-time symmetry, which overcomes the paradox. A high Q-factor silicon nitride microdisk resonator (Si3N4 MDR) is introduced to achieve frequency filtering and tuning. Moreover, the experimental results reveal that the tunable OEO generates a signal range from 3 GHz to 20 GHz with a phase noise about -120dBc/Hz at a 10 kHz offset frequency.A rapid and label free aflatoxin B1 (AFB1) microfluid sensor was proposed and tested. The device was fabricated with hollow-core photonics crystal fiber infiltrated with the AFB1 solution. The autofluorescence emitting from the AFB1 molecules was detected. selleck The sensor length was optimized. The AFB1 concentration was tested with a 4 cm long sensor. The best limit of detection was achieved as low as 1.34 ng/ml, which meets the test requirement of the national standards for AFB1 in food. The effectiveness of this sensor being applied in beer solution was also verified to be a little more sensitive than in aqueous solution. Compared with traditional AFB1 detection methods, the proposed single-ended device perfectly satisfies the demand of process control in alcoholic beverages manufacture.Multi-wavelength radiometric thermometry has a wide application prospect in many fields. However, due to unknown emissivity, the data processing algorithm remains a difficult problem. The Broyden-Fletcher-Goldfarb-Shanno (BFGS) algorithm is proposed to inverse true temperature and spectral emissivity without assuming the emissivity model. The BFGS algorithm can automatically identify the emissivity models of different trends. These simulation results show that given different initial emissivity has no significant influence on the inverse temperature and emissivity. Then, we select 0.5 as the initial emissivity and carry out the simulation experiments at 800 and 900 K, respectively. The maximum absolute error of temperature is less than 3.5 K and the computation time is less than 0.2 s. Thus, the algorithm has high precision and efficiency. Finally, the verification experiment indicates that the BFGS algorithm is effective and reliable. The proposed method can be applied to real-time temperature measurement in many industrial processes.Debye series expansion (DSE) is developed for electromagnetic (light) scattering by a charged sphere. By comparing our results with Mie theory (for a charged sphere) and with DSE (for a neutral sphere), we verify our theory numerically. DSE is employed for calculation of far-field intensity, and absorption and extinction efficiencies of charged spherical particles illuminated by a plane wave. The influences of various parameters (including surface charge, refractive index, size parameters, Debye mode, etc.) are studied. The rainbow produced by charged particles is analyzed. These results are of great significance in many fields including particle sizing, optical tweezers, etc.