About seller
05). A significant or quasi-significant increase (P = .068 and .047 for CPT and RPT, respectively) in bone mineral content was observed after both interventions. A significant reduction in fat mass (P = .017), along with a trend (P = .059) toward a reduced body mass, was observed after RPT, but not CPT (P = .076 for the group × time interaction effect). Significant benefits (P < .05) were also observed for most strength-related outcomes after RPT, but not CPT. CPT and RPT are both effective strategies for the improvement of endurance performance and bone health in professional cyclists, although the latter tends to result in greater improvements in body composition and muscle strength/power.CPT and RPT are both effective strategies for the improvement of endurance performance and bone health in professional cyclists, although the latter tends to result in greater improvements in body composition and muscle strength/power. The authors investigated the effect of foot cooling (FC) between sets in a leg press pyramid workout with resistance-trained participants. A total of 12 resistance-trained men (age = 21.8 [0.6]y; training experience = 1.7 [1]y) performed a pyramid workout, including 4 sets of 85% to 90% 1-repetition maximum leg press exercise to exhaustion with interset FC or noncooling in a repeated-measures crossover design separated by 5days. The authors immersed the participants' feet in 10°C water for 2.5minutes between sets. Two-way repeated-measures analysis of variance revealed that FC elicited significantly higher repetitions and electromyography (EMG) values of the vastus lateralis (simple main effect of condition) than did noncooling (P < .05) in the second (repetitions 11 [3.5] vs 7.75 [3.2]; EMG 63.4% [19.4%] vs 54.5% [18.4%]), third (repetitions 8.9 [3.2] vs 6.4 [2.1]; EMG 71.5% [17.4%] vs 60.6% [19.4%]), and fourth (repetitions 7.5 [2.7] vs 5.1 [2.2]; EMG 75.2% [19.6%] vs 59.3% [23.5%]) sets. The authors also detected a simple main effect of set in the FC and noncooling conditions on repetitions (P < .05) and in the FC condition on the vastus lateralis EMG values. Although the authors observed no time × trial interactions for the rating of perceived exertion, the authors observed main effects on the sets (7.7-9.6 vs 7.9-9.3, P < .05). Interset FC provides an ergogenic effect on a leg press pyramid workout and may offset fatigue, as indicated by higher repetitions and EMG response, without increasing perceived exertion.Interset FC provides an ergogenic effect on a leg press pyramid workout and may offset fatigue, as indicated by higher repetitions and EMG response, without increasing perceived exertion. To describe the intensity, load, and performance characteristics of a world-class sprinter competing in the Tour de France (TdF). Power output (PO) data were collected from 4 editions of the TdF (2013, 2014, 2016, and 2017) and analyzed. Load, intensity distribution in 5 PO zones, and the maximal mean PO for multiple durations were quantified. Stages were divided in accordance with the 4 different editions of the TdF, as well as the 4 different stage types, that is, flat (FLAT), semimountainous (SMT), mountain (MT), and (team) time trials. In addition, based on their location within the stage, mountain passes were further classified as BEGINNING, MIDDLE, or END of the stage. No differences in load, intensity, and performance characteristics were found when the 4 editions of the TdF were compared. Time trials were associated with higher intensities but a lower load compared to the other stage types. MT showed higher load and intensity values compared to FLAT and SMT stages. Selleckchem OSI-027 FLAT stages were higher in short maximal mean PO (≤1min), whereas MT stages showed higher longer endurance maximal mean PO values (≥20min). In addition, mountain passes situated at the BEGINNING of the stage were completed with a higher PO, cadence, and speed compared with mountain passes situated at the END. A world-class sprinter sustains a higher load and spends more time in the high-intensity zones when competing in the TdF than previously reported values suggested. To finish the MT stages as efficiently as possible, sprinters adopt a reverse pacing strategy.A world-class sprinter sustains a higher load and spends more time in the high-intensity zones when competing in the TdF than previously reported values suggested. To finish the MT stages as efficiently as possible, sprinters adopt a reverse pacing strategy. To investigate the relationship between prescribed (preDI), perceived (perDI), and actual delivery intensity (actDI) in cricket pace bowling. Fourteen male club-standard pace bowlers (mean [SD] age 24.2 [3.2]y) completed 1 bowling session comprising 45 deliveries. The first 15 deliveries composed the warm-up, where participants bowled 3 deliveries each at a preDI of 60%, 70%, 80%, 90%, and 95%. Bowlers reported the perDI after each delivery. The fastest delivery in the session was used as a reference to calculate relative ball-release speed for the warm-up deliveries, with this measure representing the actDI. Ball-release speed was captured by a radar gun. For perDI, there was a very large relationship with preDI (rs = .90, P < .001). Similarly, for actDI, there was a large relationship with preDI (rs = .52, P < .001). Higher concordance was observed between perDI and preDI from 60% to 80% preDI. A plateau was observed for actDI from 70% to 95% preDI. The relationship between perDI and actDI was very large and large with respect to preDI, indicating that both variables can be used to monitor delivery intensity against the planned intensity and thus ensure healthy training adaptation. The optimal preDI that allowed pace bowlers to operate at submaximal perDI but still achieve close to maximal ball-release speeds was 70%. Bowling at the optimal preDI may significantly reduce the psychophysiological load per delivery in exchange for a trivial loss in ball-release speed.The relationship between perDI and actDI was very large and large with respect to preDI, indicating that both variables can be used to monitor delivery intensity against the planned intensity and thus ensure healthy training adaptation. The optimal preDI that allowed pace bowlers to operate at submaximal perDI but still achieve close to maximal ball-release speeds was 70%. Bowling at the optimal preDI may significantly reduce the psychophysiological load per delivery in exchange for a trivial loss in ball-release speed.